Volvo Penta Autopilo Gateway A80649, 1-6 Engines
1. 12 V dc power supply (providing power to SeaTalkng.)
2. EV-2
3. Autopilot controller
4. DeviceNet adaptor cables (female) (as supplied with Raymarine DeviceNet cable kit.)
5. 12 V dc power supply (providing power to the Volvo Penta EVC interface unit.)
6. SeaTalkng R 5–way block
7. Volvo Penta EVC drive interface unit (available separately.)
8. Dedicated SeaTalkng backbone (providing power to the Volvo Penta EVC drive interface.)
9. Engine CAN bus
Power connection — Volvo Penta EVC interface
The EVC interface unit requires a 12 V power source, which must be provided to the EVC unit via a battery.
• If your vessel has a 24 V supply a suitable voltage convertor is required.
• The power source must be protected by a 5 A fuse or a circuit breaker providing equivalent protection.
• The EVC interface unit must be connected to a 12 V dc power source via a dedicated SeaTalkng backbone.
• The supplied DeviceNet to SeaTalkng adaptor cable must be used to connect the EVC interface unit to the dedicated
SeaTalkng backbone. This cable carries both data and power signals to the EVC unit.
Volvo Penta Easy Connect gateway
In case if Volvo Penta Easy Connect gateway is will be installed to the system it must be connected
from the Volvo Penta Hub directly to the naviga5on system STNG network, not in to the Volvo Penta
autopilot gateway dedicated STNG network.
|
;)
